FAQ Of Customer

The steps to start up the air compressor are usually as follows，Loosen the shipping brackets or bolts on the main frame that connect to the large base of the cabinet. These brackets or bolts are used to secure and protect the air compressor during transportation, but need to be loosened before use to ensure that the air compressor can run freely.

Connect the power cord and ground wire, and check whether the voltage is correct and whether the three-phase voltage is balanced. This is to ensure the stable operation of the air compressor.

Check whether the electrical wiring is firm and reliable. Electrical wiring is an important part of the air compressor. If the wiring is not firm or has hidden dangers, it may cause equipment failure. .Check whether the oil level in the oil and gas cylinder is at the appropriate position. An oil level that is too low may cause poor lubrication of the equipment, while an oil level that is too high may affect the normal operation of the equipment. Therefore, it is necessary to ensure that the oil level is within the normal range.

Check that the belt tension is appropriate. The belt is an important transmission component in the air compressor. If the tension is inappropriate, it may cause the belt to slip or wear too quickly, thus affecting the normal operation of the equipment.

Before starting for the first time or after a long shutdown, 0.5-1.5L air compressor oil should be injected into the compressor body through the air inlet, and the air compressor should be rotated by hand for a few turns to prevent oil loss and burning in the head when starting. damage. This is to ensure that the air compressor has enough lubricating oil when it is started, thereby protecting the equipment from damage.

After completing the above steps, you can start the air compressor according to the instructions in the operation manual. Please note that you must follow operating specifications during operation and ensure that the equipment is in a stable and reliable condition. If necessary, it is recommended to consult professionals or manufacturers for guidance.