Service

Before contacting and using the air compressor, read the operating instructions of the air compressor carefully so that we can use the air compressor to complete our work. Different types of air compressors work in different ways, and in many production fields, the air compressors used also have dif...

Generally speaking, the main part of the test is the main engine of the permanent magnet variable frequency air compressor, followed by the pipeline parts connected to the main engine of the compressor and the base of the complete air compressor. The measuring points of the compressor main engine ar...

Oil-free water-lubricated air compressors are designed to reduce dependence on environmental factors in some application scenarios that require higher air quality. It uses water as the medium for compression sealing and cooling, which is low in cost. Through advanced sealing and isolation technology...

Pulsation control devices, such as pulsation filters, shock absorbers (including commercial patented technologies based on acoustic control technology), storage without internal parts, air choke tubes, orifice plate systems and selected pipeline layouts; The basis of system design should consider t...

Oil-free water-lubricated air compressors are designed to reduce dependence on environmental factors in some application scenarios that require higher air quality. It uses water as the medium for compression sealing and cooling, which is low in cost. Through advanced sealing and isolation technology...

If the oil circuit of the air compressor is blocked, the air compressor will not work properly. The air compressor needs to be cleaned regularly to ensure the normal operation of our air compressor. The newly installed oil system must be carefully cleaned to remove oil, iron filings, welding slag,...

1. Tighten the nut correctly: If it is too loose, it will not be able to tighten the lining and cause leakage. If it is too tight, it will cause the metal around the screw hole to bulge, or the thread will slip and cause oil leakage. 2. Replace failed oil seals promptly: Many parts of the oil seals...

1. The ambient temperature is too high (air-cooled type requires ≤42℃) Solution: If the ambient temperature is too high, you can open the machine box panel to enhance the surrounding air circulation, or install several exhaust fans. If this is not possible, you can use water-cooled models. Water-...

Causes and solutions for high-voltage protection tripping. Usually the more common ones include the following: 1. The ambient temperature is too high (air-cooled type requires ≤42℃) Solution: If the ambient temperature is too high, you can open the machine box panel to enhance the surrounding ai...

Air compressors may often experience two abnormal operating phenomena: 1. The automatic air pressure switch refuses to operate when the air pressure exceeds the limit, causing the motor to fail to operate normally. The air pressure continues to rise, causing the motor to run overloaded and overload...

1) Oil separation core failure of screw air compressor The oil core separator serves to separate the compressed air and oil within the device. If the oil core separation is unsuccessful, the following two scenarios will occur: a) The oil core of the screw air compressor is clogged, which increases t...

At rated pressure, the amount of air discharged by an oil-free air compressor cannot meet the flow rate, so the discharge pressure must be reduced. The main cause of abnormal interstage pressure is air valve leakage or air leakage after piston ring wear. Find out the cause and take measures. Fault p...